Just a "Little" project of mine.

Discussion in 'Unrelated Discussion' started by KNight, February 11, 2014.

  1. KNight

    KNight Post Master General

    Messages:
    7,681
    Likes Received:
    3,268
  2. KNight

    KNight Post Master General

    Messages:
    7,681
    Likes Received:
    3,268
    I finally got some time to work on this stuff again and I finished my Vacuum Former (Testing Pending) and did some cleanup.

    [​IMG]
    [​IMG]
    [​IMG]

    I ended up rebuilding the frame for holding the plastic, I used Toggle Clamps to make it a hell of a lot easier to place and remove the plastic compared to undoing 8 bolts and had to make a special 'lid' to help keep the heat in to better melt the plastic.

    Also had to drill another few hundred holes in a much smaller size because I was a little over-zealous in selecting the drill bit.

    But now I can start actually working on other things, so that's a plus!

    Mike
  3. SolitaryCheese

    SolitaryCheese Post Master General

    Messages:
    674
    Likes Received:
    1,046
    Is that hand is what you intend to use to masturbate in the future? :rolleyes:


    (just kidding, just kidding)

Share This Page